Skip to main content
System StatusContact Support Agility Community

Jenkins Integration


Instructions for integrating Continuum with Jenkins.


To configure and test connectivity to Jenkins, see Jenkins Continuous Integration Server Setup, and then return here.

Create or Select a Jenkins Job

For purposes of testing and running through the tutorial without impacting a valid Jenkins project, it is recommended that you copy an existing job.

Another option may be to create a new Job that simply executes a shell command echos "hello world". This may be enough to start with and finish out later on.

Triggering the Build

Now we will want to trigger the Jenkins build from our pipeline. Return to the Pipeline Definition editor and edit the example stage. Click the Plugins tab then the Jenkins category. Drag the Build function to the right and drop it below the Log step.

In the Job Name box, you will need to put Jenkins job name you selected.

If the Jenkins job has parameters, you can enter them in Parameters box in a Json format as follows:

    "name1": "value1",
    "name2": "value2"

Typical parameters to pass to a build would be a branch name and commit identifier. This could tell the build to check out a specific branch and commit to build from the source repo. This information can be found in the Workspace of the pipeline instance, we will come back to passing variable parameters later.

Leave the other values on the Build step their defaults. Go ahead and make another commit / push to the source repo with the Work Item identifier in the comments. Return to the pipeline instances page and you should see another pipeline instance. Click on this pipeline instance and drill into the phase. You should see a Jenkins build number. Clicking on this will jump you into the instance log in the Jenkins user interface.

When the Jenkins build completes, either successfully or failure the status will get updated. If the build errors, the pipeline fails. If there was some other failure, such as an error triggering the build, take a look at the Log tab on the left.

If the build is failing, work through it until you have a successful build so that we can move on to the next step in the tutorial.

Go back to Adding in Continuous Integration/Build Process