Skip to main content
System StatusContact Support
VersionOne Community

Applying Filters to a Report

This feature is available in Enterprise and Ultimate editions.

editions-eu.png

Overview

Report filters allow you to narrow the scope of a report so you can see a subset of data at any given time. For example, instead of displaying all workitems in a sprint/iteration, you might apply a filter to display only workitems in a certain status.

Here are a few things to keep in mind when using filters:

  • Each report contains a default set of filters that you can us "as is" or customize to show only what you want to see.

  • Filters are persistent. The first time you run a report, VersionOne remembers the filters you select and automatically applies them the next time you access the report.

  • Filters are specific to each report. If you move between reports (e.g., Burndown to Estimate Trend), filter values on the new page are set to the default values or they are set to the values you used the last time you ran that report. The filter values do not change to the ones you selected on the previous report.

Steps

  1. On any report page, select any combination of filters from the drop-down lists.

  2. Click Go to apply the filters and generate the report. Click Reset to reset the filters to their default values.

  • Was this article helpful?